ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER

ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER

Manufactured by DV Verano, Ukraine, Odessa, 65039, 94, Kanatnaya str. off.1
VEGA1/VEGA1.5/VEGA2/VEGA3/VEGA5

 

 

Owner r’s passport
With technical descriptions, Odessa 2010

NOTICE: Do not try to repair or disassemble the generator, since generator has built-in protection against unauthorized breach and opening, which can call fires, leading to melting and demagnetization of the magnets.
The cable must be 3+1 with at least 6mm². Tree veins through terminal blocks shall be connected to the three strands of generator cable, the generator, one extra attached to the ground to the general contour of the grounding.
Due to the fact that the controller that the controller is using capacitor chain to convert the voltage, care should be taken to preclude the accidental shorting of the terminal outputs between each other, when you connect various loads to the power supply.
When using heaters, batteries and inverters with ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER VEGA it is necessary to follow instructions for use of these products.

5. Structure and principle of operation of  ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER       VEGA 1/5 kW

ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGERVEGA is a synchronous gearless multi-pole brushless generator, made by Verano. Production range of VEGA includes models from 1 to 5 kW, with outer rotor, ie body rotates the generator. Case of the generator is fully protected from the external environment, so that dust, moisture, salt and chemicals have no effect on the machine. This is an important factor, indicating the reliability of the device.

Possibility of installation and using multiple systems simultaneously

 

 

Regenerating system of the rotor uses module of accelerating electromagnetic coils, 8 ohms, TIME of OPENING is fixed and is 1.8 DEGREES No matter what the Rotor speed is, "CEMF" USED FOR REGENERATION AMPLITUDE PULSE 350 regeneration efficiency 300%
Synchronous generator,  by DV Verano, with N-pole facing outwards permanent magnets, ensures a constant rotational speed under the control of the impact of jogging accelerating special geometry electromagnetic coils


High-voltage negative spikes on collecting coils transfer energy to batteries, to support continuous rotation. This is a new approach to the well-known Adams motor design. 

 
Generated by the generator three-phase alternating current goes into the controller, which multiplies and accumulates the energy over time, then outputs it in the form of intermittent high-current pulses thus charging the batteries of the inverter.

Converting EMF of free running generator into statically stored charge of the batteries, with the function of the accumulation and multiplication, after reaching the threshold energy is dumped to the battery banks, after being converted into pulses of charging current, frequency is determined by the time of integration (energy storage), speed, and also by power of the generator, in terms of additional voltage from the turnover.
For 1.5 kW - 1.2 V
For 2 kW - 2.47 V
Time management of the accumulation of energy is made by electronic control circuit which realizes functions of electronic gear multiplier.

Output parameters
Output pulse current from battery controller is 5-50 A, repetition rate is determined by the energy of rotor rotation
Output voltage is linear and is determined like additional 2, 147 V for every additional rotation of the generator. Using the regenerating of rotation of the rotor is possible only with small loads on the shaft, controller supplied with the equipment has a feature of picking of electricity produced in the "idle mode" with the function of multiplication and accumulation of energy in a form of  the electrostatic charge of predefined power, which is followed by converting it to the charging pulse  current required for charging batteries.


Back emf is a Lenz effect reversed polarity current surge that happens whenever current is suddenly stopped - as happens all the time in a pulse motor. Many people confuse back emf with the negative energy manifested in the Adams motor. Transducted negative time reversed energy flows backwards to its source, while the collection of this energy is done by collecting coils and goes through a special electronic driver on the recuperative charging batteries for future electric push reel, this is the self-healing, pushing part of the system.
The problem that confronted Sir Adams, as well as all his followers was  in receiving high return from this generator, it was necessary to overcome the back EMF (also called counter-emf cEMF) from the stator windings.
In VEGA  system there is no such problem, because specially designed controller / multiplier uses mostly EMF from idling generator and when the desired number of revs is reached – uses rotational inertia of the generator.
Using MOSFET- type transistor, with commuting 250v+ capacitor, combined with a simple bypass for the recharge of the source.

A- Battery voltage
B - Battery charging current (average value) - 0.7 x I max
The load for the system is a battery with current-limiting resistor. For small capacitive batteries, the load can be directly connected to the device.
Internal switches
A - built-in automatic switch – which is used for emergency braking of the turbine – UP -turbine is stopped
B  - double switch - which is used for breaking the circuit charging the battery - position DOWN - circuit is closed, the battery charging current is fed

Operational mode of the CONTROLLER 0 +25 degrees Celsius. Install inside only. Optionally you can order a closed package for the controller system to work in a wider range of temperatures

8 batteries 12V-200Ah needs to be connected to the device.
  Charging the battery is done with high-frequency ultrashort impulses (voltage pulse reaches 600 V) and current pulses of 0.1-0.5S to battery

       Recommendations for effective usage of ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER  VEGA 1/5kW

For the most efficient use of purchased ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER VEGA system we recommend to:
1. carefully read the owner’s manual
2. number rechargeable battery generator can be increased by increasing the number of the controllers connected in parallel. Note that using the system for charging the battery must be based on the selection of adequate capacities of the battery can charge the battery to the acquired system. Always remember that the system acquired by you charges the battery, but the time to charge the battery is directly proportional to the number of batteries you have purchased, their type and energy capacity
3. always remember that ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGERVEGA  VEGA works only through the buffer, which is the battery. Using the system with the inverter associated with the central grid is not effective.
4. VEGA power can be extended by increasing the number of used generators. With an increase in the number of used generators, number of controllers increases by ½. Ie with every 2 new generators 1 new controller needs to be used.

7. Notes on packaging, transporting and storage

The generator with a system of coils is supplied in an aluminum box,
Dimensions WxHxD = 640x640x400 mm
Dimensions of packing WxHxD mm = 680x680x420
Gross Weight -
___________________

The controller comes in a wall cabinet,
dimensions WxHxD = 450x600x250 mm

Dimensions of packing WxHxD = 500x620x300 mm

7.1. ADAMS GENERATOR inspired / OVER UNITY DEVICE / FREE ENERGY CHARGER VEGA 1/5kW comes in an original packaging. If you need to transfer it to a new location of installation, you should observe following conditions:
• All components should be laid to their places in their original packaging;
• sockets at the ends of cables should be wrapped in plastic film or oiled paper, the output wires of the generator should be short-circuited by connecting them together
• Do not turn over boxes, handle the with care, with bottom down.


7.2. VEGA should be stored in the packaging in a closed unheated rooms with natural ventilation at temperatures from - 40 to + 50 ° C in the absence of environmental acid and other vapors, which may harm system units and parts of the controller. High moisture is not allowed the room of storage.
7.3. In the transport use labels: Top, handle with care, afraid of dampness.
Transportation of VEGA must be made only in a packaging provided by manufacturer in accordance with the rules of carriage of goods in transport

9. Certificate of acceptance

Are manufactured and accepted in accordance with the specifications and arefound eligible for operation.
Manufacturer reserves the right to change specifications without notice

 WARRANTY

       These warranties do not limit legal rights of consumers.

10.1. The warranty covers defects of production for one year from date of purchase, including parts and replacement costs.

10.2. This warranty is valid only if the port is filled properly by the seller and indicates the date of purchase.

10.3. This warranty applies only to products used in non-commercial purposes.

10.4 The warranty does not apply if failure is due to:
   • unintended in the passport application VEGA or parts thereof (including electrical overload), the connection to inappropriate (failure) converter or to the faulty electrical device;
   • damage or changing in settings of VEGA or some of its units in connection with the hit or falling of devices;
   • Improper installation and assembly of mechanical and electrical components or improper care and maintenance;
   • damage to the product in a natural disaster, flood, fire, or other similar circumstances beyond the control of the manufacturer, as well as the operation of the product or its parts in the climatic conditions which are not allowed by this manual;
   • changes in product design without the notice of the manufacturer;
   • tampering the seals, fasteners, established by the manufacturer without his presence or the presence of a person authorized by the manufacturer; operation of the product without a load, the experiments with VEGA without the load, shorting of the generator at more than 10 rpm in manual mode, using wires from the generator.
   • If the product was operated with uncorrected defects.
         
10.5 Any claims for quality and performance products are accepted and removed only after verification of them by specialist of the manufacturer or by person authorized by the manufacturer .

10.6 This warranty does not cover damage of wear parts manufactured by other manufacturers (lamps, LEDs, contact brushes, etc.).

10.7 The manufacturer shall have the right to refuse all or partly of warranty, in case of delayed notification of defects found by the buyer of the product.

10.8 The warranty on the system VEGA does not covers batteries using with EM coils